HAWTHORNE, N.J. — September 2013 — This Radiant Energy Systems’ 21 ft. vertical electric and gas
fired infrared tower oven is custom designed for drying, baking and sintering of PTFE coatings on
fiberglass fabrics. A new, upgraded design for the gas burners is supplied. This new design
eliminates the need for high temperature insulation. The heater’s outer surfaces- edges and back,
are cool to the touch.
This more efficient oven system was engineered for a 65″ woven fiberglass line. There are two
12″ x 71″ drying zones that combine electric infrared with air. The bake zone is 24″ in direction
of product travel. Two gas fired infrared burners are mounted in a staggered configuration with
each heater opposite an insulated reflector panel. This design allows the product temperature to
Radiant Energy Systems’ Electric and Gas Infrared Tower Oven for PTFE Coating of Fiberglass
Webs 21′ High X 30″ Width x 80″ Deep
The sinter zone is 32″ in direction of product travel and contains four staggered gas
infrared heaters. These heaters are also mounted in a staggered configuration with each heater
opposite an insulated reflector panel.
Posted September 10, 2013
Source: Radiant Energy Systems